Tecfluid FLOMAT Series Manuale Utente

FLOMAT FX Electromagnetic insertion sensor Series Instructions Manual R-MI-FlomatFX Rev.: 1 English version instrumentation for fluids

7 POSSIBLE PROBLEMS WHEN COMMISSIONING 7.1 No flow rate indication Check that the cables for remote electronic units have been correctly connected.

8 MAINTENANCE It is recommended to clean the electrodes in installations where appreciable incrustations or sedimentations can occur. Dirty electrode

WARRANTY Tecfluid S.A. GUARANTEES ALL ITS PRODUCTS FOR A PERIOD OF 24 MONTHS, after consignment, against all defects in materials and workmanship. Thi

2 TABLE OF CONTENTS 1 WORKING PRINCIPLE …………………... 3 2 RECEPTION ...

3 1 WORKING PRINCIPLE The Flomat electromagnetic insertion flowmeters are based on Faraday’s induction law. When an electrically conductive liquid flo

Downstream from the sensor, the minimum recommended distance from a disturbing element is 5 x DN. 3.2 Straight pipe sections The point where the Flom

3.4 Valves Control valves or stop cocks should always be installed downstream from the sensor to assure that the pipe is always full of liquid. 3.3 Mi

6 3.6 Vibrations Vibrations of the pipes should be avoided by anchoring the pipe before and after the sensor.

7 For DN80 and greater, there are three lengths for each of the two types of fittings. The process of putting the insert in should be done with some

8 Example: Suppose a pipe of 300 mm inner diameter (DN300) and 5.5 mm thick. In the table we can see that the distance that the insertion fitting must

9 Drill a 48.5 mm diameter hole in the pipe to insert the fitting and weld the fitting to the pipe. The axis of the insertion fitting should be perfec